the SHOP

Tuesday, December 15

Day 15

On Tuesday night, Joe taught them the secret of the offset hole.

The cradle case was inverted on the maple bench, its four corner posts pointing toward the ceiling, waiting to receive the two curved white oak rockers.

Cal held the front rocker upside down, sliding its twin tenons into the deep mortises Dan had chopped into the bottom of the posts. It slid home with a soft, pneumatic whuff of trapped air.

“Fits like a vault door,” Cal said, running his fingers over the seam. “We drill straight through the post and tenon now?”

“Not straight,” Joe said, stepping up to the bench with the iron hand-brace and a three-eighths spoon bit. “I bored Sunday’s holes before you got here. Watch how. If you bore through the post and the tenon together in one straight line, the peg just sits there. Come January, when the furnace dries the house out, the wood shrinks a hair and the rocker starts to wobble.”

Joe pulled the rocker back out and bored through the walls of the hollow mortise. Then he slid the tenon home again, set the point of the bit in the hole, and tapped it once to mark the center on the tenon cheek. He pulled the rocker out a second time, set the tip of the bit one-sixteenth of an inch closer to the shoulder, toward the base of the joint, and bored the tenon there.

“Wait,” Cal said. “If you drill the hole in the tenon a sixteenth of an inch off-center from the hole in the post, the holes won’t line up. The peg won’t go through.”

“Watch,” Joe said.

He handed Dan an eight-inch white oak peg that had been whittled octagonal and tapered to a blunt point at the nose, dipped in hot beeswax. They slid the rocker back into the post. Looking through the hole, Dan could see the mismatch, the inner hole sitting stubbornly out of alignment with the outer one.

“Drive it, Cal,” Joe said.

Cal raised the beechwood mallet and struck the oak peg.

The tapered nose found the offset hole in the tenon and wedged. Cal struck it again, a clean, ringing thwack that echoed off the brick walls. As the thick belly of the oak peg forced its way through the misaligned holes, the entire sixty-pound cradle frame gave a deep, resonant creak.

A tiny bead of wax squeezed out of the seam. The offset peg acted like a cam, hauling the shoulder of the rocker down tight against the post.

Cal laid his palm against the joint. The seam had vanished. Post and rocker had been pulled together by the mismatch so tightly that a razor blade could not have found the gap.

“Draw-boring,” Joe said, his dark eyes resting first on Cal, then on Dan.

Cal looked at the driven peg for a long moment. Then he looked across the bench at his father.

“Give me the brace, Dad,” Cal said. “Let’s bore the back post.”

Day 15 of 24